kitchen stand M

79x61x25 cm (31x24x10 inches);

stainless steel, easy to hang on the wall; for plates, cups cutlery etc.;

this stand we received from a new supplier, they are very well made, just 5,- € more; the inscription and the cutlery holder is little different than pictured (the ready build up ones we only send on a pallet).

Assembly instruction:
1. check and clean all the elements and hammer them if they need some work...
2. then mount the 4 big frame elements. The 2 pcs. left and right has to have the holes for the wall-hanging at the back. On top are the small holes for the triangle to fix it strong (better tighten the screws only loose, not to strong first). The top pcs. has also the triangle holes on the top. The triangles fits best between the vertical and the horizontal elements. The bottom element has holes in the middle so that water can run out and the long holes for the cutlery in front. When the frame is ready you can tighten the screws strong but take care that you have a right triangle (more or less, it is never exact!!). You can also tighten all srews at the end...
3. fix the third horizontal element, with the text to the front.
4. the middle vertical element has only one egde without a cut.This egde needs to be on the back/ bottom.
5. then mount the last small horizontal element.
6. to mount the round bars to hold plates better first stick the bars in the holes of the holder and then start with the front elements, cause them you can better fix from the back.
7. fix the hooks and check all screws they are strongly fixed.